AISY: On board electronics (modulator)


OAS40xx

Connexion:

  1. Opsommingsteken 1 connector for the antenna, Harting SubD9 type

  2. Opsommingsteken 1 connector for the supply and the I/Os, Harting SubD25 type


Supply:

  1. Opsommingsteken 24 Volt DC +/- 20%


Consumption:

  1. Opsommingsteken 50mA in standby

  2. Opsommingsteken 2A during transmission

  1. On board electronics goes inside the vehicles.  They are available as Eurocard format (100 * 160 mm) with a width of 9TE (45 mm).

Specifications

Installation

The boards can be placed in any 3U 19” shelf slot on bard, if available.

All connectors are located on the front panel.

       
We can also provide with these shelves (under reference OAS4000).


If there is no room for a shelf, we can provide the electronics in a ABS housing, with lateral fitting sing 4 screws. The housings are slightly larger than the boards (about 120 * 200 * 60 mm).

 

Inputs / Outputs:

  1. Opsommingsteken  1 floating contact / life signal

  2. Opsommingsteken  3 floating contact depending of the application

  3. Opsommingsteken  4 floating inputs depending of the application

  4. Opsommingsteken  floating contacts max 2A@30V DC

  5. Opsommingsteken  floating inputs 24 Volts +/- 30%,10 mA

  6. Opsommingsteken  1 serial line full duplex CL 0-20 mA


Visualisation:

  1. Opsommingsteken  1 LED life

  2. Opsommingsteken  1 LED carrier detection

  3. Opsommingsteken  2 LEDs depending of the application

   Back                                                                                                                       Next